STARLIGHT / Snowflake Box / GEOMETRIC CURIOSITIES
Finished envelope: 96.8 x 110.4 x 96.8 mm (width x height x depth; external tree cord excluded).
7 printed parts on 1 build plate(s), plus a separate joint test.
Solid-volume PLA estimate: 42.3 g. Preview colours are optional.

PRINT OPTIONS INCLUDED BY DEFAULT
Open each plate-NN.3mf as a PROJECT in Bambu Studio and accept its saved settings.
Bambu X1C / 0.4 mm nozzle / Bambu PLA Matte / 0.20 mm layers / 3 walls.
Automatic supports OFF, raft OFF, brim OFF. Keep every part flat as supplied.
Outer / inner walls: 30 / 40 mm/s. Wall acceleration: 500 / 700 mm/s2.
Choose the real plate, filament and AMS slot before slicing. Use a clean plate
and review first-layer adhesion. Do not stand these assembled models upright
to print them. Small parts and the broad flat panels replace tall support fins.
Do not scale STLs to tune a joint: adjust the Studio parameter and export again.

ASSEMBLY
Print the small corner-joint practice pieces first. This box uses glued butt joints; there are no snap tabs.
1. Lay the bottom cap flat. Glue the left and right panels on top, with their outside edges aligned with the cap. Fit the front and back panels against the ends of the side panels. Their longer edges span the full outside width. Keep the box square and allow the adhesive to cure.
2. Tie fine thread around the inside corner of the top cap, next to its external hanging eye. Suspend the little star so it will hang near the centre when the box is hung from that corner.
3. Glue the top cap onto all four walls. After curing, thread the tree cord through the external corner eye. Handle the border, not the thin snowflake branches. ASSEMBLY.svg shows the six panel positions; numbers match the STL filenames.

The kit includes a numbered ASSEMBLY.svg guide and exact Studio design JSON.
Provide fine thread, tree-hanging cord, and adhesive suitable for PLA.
All structural joints require adhesive; no snap retention is claimed.
Let adhesive cure fully and test retention over a soft surface before hanging.

Meshes and STL round trips are checked on export. Physical print quality,
assembly fit, movement and hanging strength are not yet tested. Slice and
review each customized project in Bambu Studio before printing.
